Table of Contents
Advertisement
13
14
If it moves more than 1 in. (2.5 cm), you can try:
• Tightening the belt more; OR
• Reinstalling the car seat; OR
• Changing to a different seating location; OR
• Switching to LATCH: lower anchor belt installation. See
page 47.
15
45
Tighten Top Tether
Push firmly on the back of the
car seat and pull the free end
of the tether strap to remove
all slack.
Check Belt Tightness
• Hold the car seat ONLY at
the belt path with your
non-dominant hand.
• Push and pull the car seat
from side to side.
• The car seat should not move
more than 1 in. (2.5 cm).
Replace Headrest Pad
Fasten all the headrest pad
fasteners.
Adjust the headrest/harness
back to the correct position for
your child.
For
Forward-Facing Child
Fit, see page 12.
6
Finished!
Forward-Facing
Vehicle Belt
+
Top Tether
Install
When used correctly, the AutoLock
will lock the vehicle belt in place.
After the car seat has been
installed, if your car has a
switchable retractor, you MUST
also use it to lock the belt.
Review pages 21-24 and your
vehicle owner's manual to
determine how to lock the belt with
the retractor.
Check the tightness of the install
often to make sure it has not
loosened.
Securing Child in Car Seat
To properly secure your child in the
car seat, see pages 53-55.
Check your child's fit often and
make any needed adjustments to
the car seat as they grow.
46
Advertisement
Table of Contents
