Table of Contents
Advertisement
3
Rear-Facing
AutoLock
29
Recline Car Seat
Squeeze the recline handle
and rotate the car seat to any
blue position
that will make
the
Level Line
parallel with
the ground.
IMPORTANT!
If you will be using the
AutoLock:
DO NOT pull the vehicle belt
all the way out to lock it
BEFORE routing the belt.
This will make threading the
shoulder belt into the AutoLock
easier.
If you will not be using the
AutoLock:
Review pages 21-24 and your
vehicle owner's manual to
determine what kind of vehicle
belt you have and how to lock
a car seat in place.
4
It may be easier for you to route the vehicle belt if you undo
the seat pad fasteners and pull the seat pad off the front of
the car seat.
• Remove the cup holders. Twist counterclockwise and lift.
• Pull the car seat pad off the front of the car seat to reveal the
Rear-Facing Belt
Path.
• You will see the lower anchor belt when you pull back the pad.
DO NOT remove this belt from its storage location. The vehicle
belt will be routed over top of it.
5
Route Vehicle Belt
• Thread the vehicle belt into
Rear-Facing Belt Path
the
opening.
• You can locate the seat
belt latch plate by feeling it
through the 3rd buckle slot
in seat pad.
• Pull it across the seat and in
front of the car seat buckle.
• Then thread it out through
the other belt path opening.
• DO NOT twist the belt.
TIP
Buckle Vehicle Belt
continued on next page
30
Advertisement
Table of Contents
