Table of Contents
Advertisement
2
Remove Connector with Adjuster from Storage
• Press the red release button on the connector with the
adjuster closest to it and pull it out of the storage location.
• Press the adjuster's button and pull the belt to loosen.
• Then put the connector through the
Belt Path
opening on the left as shown in the above
illustration.
3
Remove Connector without Adjuster from Storage
• Press the red release button on the connector without the
adjuster and pull it out of the storage location.
• Then put the connector through the
Belt Path
opening on the right as shown in the above
illustration.
• DO NOT twist the belt.
4
Belt in front of buckle strap
35
Finished Lower Anchor Belt Routing
Rear-Facing
Rear-Facing
Adjuster
5
6
7
Place Car Seat Rear-
Facing in Back Seat
Check Rear-Facing Level
Line
The
Level Line
MUST be
parallel with the ground when
used Rear-Facing.
Recline the car seat to make
the
Level Line
parallel with the
ground. See step 7.
Recline Car Seat
Squeeze the recline handle
and rotate the car seat to any
blue position
that will make
the
Level Line
parallel with
the ground.
continued on next page
36
Advertisement
Table of Contents
