Plugging In/Turning On The Printer - MINOLTA-QMS Magicolor 2200 DP Installation Manual

Konica minolta magicolor 2200 dp: installation guide
Hide thumbs Also See for Magicolor 2200 DP:
Table of Contents

Advertisement

Plugging in/Turning on the Printer

1
Make sure the printer is turned off.
2
Plug the printer power cord into the
printer and into the dedicated,
grounded, surge-protected electrical
outlet.
WARNING!
Do not overload the outlet. For products installed outside North America, do not connect the
groundwire to gas or water pipes or grounding for telephones.
3
Turn on the printer.
After a brief warmup, your printer prints a startup page
and displays " IDLE " on the message window. If
" IDLE " is not displayed in the message window after the
power switch is turned on, the setup operation is not pro-
ceeding correctly or the printer may be malfunctioning.
Recheck the setup. If the startup page doesn't print or the
print quality is not good, skip ahead to "Troubleshoot-
ing" on page 50.
5 "
The printer automatically switches to power-saving mode after 60 minutes of
inactivity. In the Administration/Engine/Energy Saver menu, you can change the
number of minutes before the printer switches to power-saving mode.
5 "
In compliance with UL guidelines, "The appliance inlet is considered to be the main
disconnect device."
32
Plugging in/Turning on the Printer

Advertisement

Table of Contents
loading

This manual is also suitable for:

Magicolor 2200 desklaser

Table of Contents