Font; Character Map; Line Numbering; Tab Stops - QMS 2025 Administrator's Manual

This option specifies the font to be used to print the current job. Any
PostScript fonts available on the printer can be used. To see a list of
PostScript fonts available, print an advanced status page. The default
is Courier.
This option is a five-digit value which specifies, in increments of .01
point, the point size of the font to be used to print the current print job.
The range is from 400 (4 points) to 25600 (256 points). The default is
00880 (8.8 points).
This selection specifies the type of character map to be used. The
choices are ASCII and EBCDIC. The default is ASCII.
Line numbering specifies that a five-digit number is to be prefixed to
the beginning of each line. The choices are On and Off with Off being
the default.
This option specifies the number of spaces between tab stops. The
minimum number of tab stops is 0 and the maximum is 256. The
default is 8.
Use this option to stipulate whether each line feed in the print job is
translated to a carriage return/line feed combination. The choices are
On and Off with On being the default.