Def Job Prio; End Job Mode - QMS 2025 Administrator's Manual

can be used at a time. The default is QMS EOD. Refer to QMS Crown
Network Notes for more information on End Job Mode.
The Def Job Prio (Default Job Priority) option determines which jobs
are printed first, according to the interface from which they are
received, when jobs are received simultaneously. The range is from
001 to 100. The default is 001, which is the highest priority.
This option sets the binary communications protocol (BCP) for com-
municating over a serial, parallel, or optional network interface to a
PostScript printer. Binary communications protocol allows any 8-bit
binary value (0-255) to be treated as data, while allowing a few of the
values to function as special control characters. When communicat-
ing 8-bit binary data in Binary or Binary Fixed mode, the printer uses
the quoting mechanism of the BCP to distinguish between the special
control characters and print job binary data.
To differentiate data from the special control characters, any data that
is the same as one of the following special control characters must be
quoted:
ASCII ASCII
Keyboard Name
^A SOH
^C ETX
^D EOT
^E ENQ
^Q DC1
^S DC3
^T DC4
^\ FS
ASCII Control
Hex Value Function
0x01 Quote data character
0x03 Abort job and flush to end of file
0x04 End-of-file marker
0x05 (Reserved for future use)
0x11 XON in XON/XOFF flow control
0x13 XOFF in XON/XOFF flow control
0x14 Job status request
0x1C (Reserved for future use)