Table of Contents
Advertisement
ing the two pages, it's easy to see the difference in screens, in type
quality, and in precision of curves and diagonal lines.
To print a calibration page, go to the Administration/Special Pages/
Calibration page menu. Choices are Yes and No with a default of Yes.
Select Yes, and a calibration page prints when you exit from the
menu.
A header page is a separator page that prints before a print job to
help users sort out their jobs. This option controls whether a header
page prints before each job. This option is either On or Off with the
default of Off. (See QMS Crown Document Option Commands for
information on header page contents.)
This option selects the input bin from which the header page is
printed. Upper selects the upper bin, Lower selects the lower bin, and
LCIT selects the optional large-capacity or large-large-capacity input
bin, if one is installed. The default value is Upper.
This option allows you to configure if and when a trailer page is
printed after each job. Trailer pages can help users sort out jobs. The
choices are On, Off, On Error, and Errors Only. The default value is
Off.
For LN03 Plus print jobs only, setting this option to On Error prints a
trailer page (with error messages generated during processing and
printing of your job) only if an error occurred. Setting it to Errors Only
prints error messages on the trailer page and omits other trailer page
information. (See QMS Crown Document Option Commands for infor-
mation on the trailer page contents.)
Advertisement
Table of Contents
