The options in the Startup Options submenu, shown below, allow you
to configure your printer to run certain options every time the printer is
turned on.
STARTUP OPTIONS
DO ERROR HANDLER
The Do Start Page option allows you to decide whether the printer
produces a start-up page each time it is turned on. The options are
Yes and No with the default being Yes. This option takes effect when
the printer is turned off and on again.
Sys Start is a PostScript file residing on the printer's hard disk. When
Do Sys Start is enabled, the controller checks the hard disk for a
SYS/START file each time it is turned on and executes the file. The
options are Yes and No. The default is Yes.
ADMINISTRATION
STARTUP OPTIONS
STARTUP OPTIONS
DO START PAGE
STARTUP OPTIONS
DO SYS START