Table of Contents
Advertisement
Attention:
The screw driver is equipped with a reversible motor and a left
shut-off clutch, that means in view of from the air inlet side,
the screwdriver is running contrary the clockwise direction.
Specialities of reverse mode:
Use the air connector axially located with the screwdriver and start the
·
tool by pushing it down (push to start). The screwdriver will start running
in left hand direction to switch off when the preset torque is reached.
Use the air connector located on the side. The screwdriver will
·
immediately start running in right hand rotation (remote start) and with its
max. torque capacity.
The air connector not used must be vented to prevent reduction of
·
performance.
4.1. Range and Exchange of Clutch Spring
The torque range of the DEPRAG Screwdriver is adjustable. Please see a
listing for the torque ranges of the color-coded springs below.
Torque Range of the individual clutch spring:
.
-Æ
PART NO
WIRE
323035/1
2,5 mm Green appx. 1,4 Nm / 12 in.lbs.
323036
2,2 mm
323037
1,6 mm Yellow appx. 0,2 Nm / 2 in.lbs.
All torque values are based on 90-PSI (6,3 bar) air pressure. Torque values
are estimated data which may differ – depending on the type of screw joint.
To avoid loosing individual small parts, it is recommended to
only disassemble the machine on top of a flat work surface.
COLOR
TORQUE
Red
appx. 0,5 Nm / 4,4 in.lbs. appx. 1,5 Nm / 13 in.lbs.
"
."
MIN
appx. 2,0 Nm / 18 in.lbs.
appx. 0,6 Nm / 5,3 in.lbs.
12
"
."
TORQUE
MAX
Advertisement
Table of Contents
