Disposal Of Packing Materials; Electrical Connection; Filling The Water Tank; Setting The Water Hardness - LAVAZZA BLUE LB2000 Instructions For Installation And Use Manual

The illustration shows the minimum spaces for accessing:
• the control panel on the front
• the components that may require servicing in case of machine
malfunctioning.
400
100
200
After positioning the packing container near the installation site, proceed as
follows:
• make sure that the original packing container is closed and intact and has
not been tampered with during transport;
• open the packing;
• check the condition and model of the packed machine;
• check the contents of the bag of accessories enclosed with the machine
(see "9.3 List of accessories supplied");
• remove the machine from its original packing container;
• free it from any remaining packing materials;
• then lift the machine and position it in the site prepared beforehand.
9.5.

Disposal of packing materials

After the packing container has been opened, the packing materials should
be segregated according to type and disposed of in accordance with the
regulations in force in the user's country.
We recommend keeping the packing container for future conveyance
or transport.
9.6.

Electrical connection

This job may be performed only by specialised technical personnel
or by the service provider.
The machine is designed to work with single-phase voltage: the voltage rating
is shown on the identification plate (1.4 Machine identification).
Before plugging in the machine, make sure that the ON/OFF switch is positioned
on "0".
The Service provider makes and is responsible for the electrical connection of
the machine.
The machine must be connected to the power supply line via the plug installed
on the power cord, bearing in mind:
• The laws and technical standards in force at the time of installation;
• The technical data shown on the plate on the side of the machine.
Warning: The electrical socket to which the machine is connected
must be situated within convenient reach of users, so that they
can easily disconnect the machine from the mains power line when ne-
cessary.
It is forbidden to:
• Use extension cords of any type.
• Replace the original plug.
• Use adaptors.
9.7.
Before starting up the machine, you must fill the water tank with fresh drinking
water.
Using the key supplied with the machine, open the lid of the water tank and
lift it off.
200
200
Dimensions in mm
Lift out the tank using the handle provided.
Fill the tank with fresh drinking water.
After filling the water tank, set it back in place, taking care to position it correctly;
in this manner the valve situated at the bottom will open and allow the machine
to work properly.
Replace the lid on the water tank.
Lock the lid in place using the key provided.
Now the machine is ready to be switched on and to dispense drinks.
9.8
This function allows you to set the degree of water hardness so that the machine
will signal the need for a descaling treatment at the right time.
The hardness of tap water may vary depending on the region.
For this reason, the appliance can be set according to the water hardness in the
place where it is to be used, expressed on a scale of 0 to 4.

Filling the water tank

Warning! The tank may be filled only with fresh drinking water. Hot
or carbonated water or other liquids will damage the machine.
The water tank may be filled only by the service provider or a
specialised technician.
When filling the tank, never exceed the maximum level.

Setting the water hardness.

Warning. To make this setting, carefully read the directions
provided in section 10.
• 25 •