The Basics
Connecting the DCS Pro Back Plus to the
Camera Body
If using a MAMIYA RZ67 PRO II, you must first
1
attach a DCS Pro Back Plus MAMIYA
interface plate
(page
necessary with the HASSELBLAD 555ELD,
553ELX, 503CXi or 503CW.)
2
Remove the protective body cap from the DCS
Pro Back Plus. (Pull the bottom off, then lift the
top slightly to clear the release button.)
Contents
Back
34). (This is not
Next
IMPORTANT:
Do not touch or strike the exposed IR filter (or
anti-aliasing filter) or set it down on a surface.
3
Using isopropyl alcohol on a lint-free lens
cleaning tissue, clean the contact pads on the
DCS Pro Back Plus and the contact pins and
locating posts on the camera body.
IMPORTANT:
Do not connect a power source to the DCS Pro
Back Plus until it is connected to the camera
body or the MAMIYA Interface Plate.
Index
35