The Basics; Assembling The Camera - Kodak DCS Pro Back Plus User Manual

The Basics

Assembling the Camera

The Basics
Do the following before using your camera.
In this manual, the term "camera" refers to
"
the camera body with attached DCS Pro
Back Plus.
1 Verify that your computer meets system
requirements (page
2 Install an included focus screen overlay
(page 19).
Connect the DCS Pro Back to the
3
HASSELBLAD 555ELD, 553ELX, 503CXi or
503CW (page 34)
Plus MAMIYA interface plate that has been
attached to the MAMIYA RZ67 PRO II
(page 34).
Contents Back
12).
or to the DCS Pro Back
Next
4 Connect the following cables, as needed:
DCS Pro Back Plus Lens Shutter Sync cord
!
(page 38)
Flash Sync cable
!
IEEE 1394 cable
!
(page 61)
S-Video cable
!
If you are using a HASSELBLAD 503CW,
503CXi or 553ELX camera body, connect the
KODAK PROFESSIONAL DCS Pro Back
Plus 503CW/CXi Cable Assembly or the
553ELX Cable Assembly. Follow the
instructions included with your cable.
5 Follow the instructions for using your camera
connected to a computer
portable mode (page
Index
(page 39)
(page 55) or battery cable
(page 86)
(page 54) or in
60).
33