2-6.5 Vga Card (Jvga1); 2-6.6 Clear Cmos Data (Jbat1); 2-6.7 Wake On Lan (Wol) Function (Jwol1) - SOLTEK SL-65EB User Manual

65EB

2-6.5 VGA CARD (JVGA1)

JVGA1 : VGA CARD
For PCI VGA Card
Normal (default)
NOTE: This jumper is set for the PCI VGA Card only. Open this
jumper when the system is not able to boot up. If you use
AGP Card, it is important to leave "JVGA1" at default setting.

2-6.6 CLEAR CMOS DATA (JBAT1)

JBAT1: CLEAR CMOS DATA
Clear CMOS Data
Retain Data (default)
NOTE: We recommend user to unplug the power cord from ATX
power supply to take precautions. Clear CMOS memory by
shorting this jumper pin 2 & pin3 momentarily, and then
remove the cap back to pin 1 & pin2 to retain original CMOS
setting.

2-6.7 WAKE ON LAN (WOL) FUNCTION (JWOL1)

JWOL1 : WAKE ON LAN (WOL) FUNCTION
Connect the Wake On LAN signal from LAN card
to JWOL1
This connector connects to a LAN card with a Wake On LAN output.
The connector powers up the system when a wake-up packet or signal is
received through the LAN card.
This feature requires that Wake On LAN feature is enabled at the
BIOS "Power Management Setup" and that your system has an ATX
power supply with at least
18
JVGA1
JVGA1
+5V standby
GND
PME
720mA / +5V standby power.
3
JBAT1
1
3
JBAT1
1
JWOL1