SOLTEK SL-65EB User Manual page 47

IDE Primary
Master / Slave PIO
Secondary
Master / Slave PIO
IDE Primary
Master / Slave UDMA
Secondary
Master / Slave UDMA
On-Chip Primary/
Secondary PCI IDE
USB Keyboard Sup-
Init Display First This option allows you to decide to activate PCI Slot
IDE HDD Block Mode Block mode is also called block transfer, multiple
Choose Auto or Mode 0~4. The BIOS will detect the
HDD mode type automatically when you choose Auto.
You need to set to a lower mode than Auto when your
hard disk becomes unstable.
The choice: Auto, Mode 0, Mode 1, Mode 2, Mode 3,
Ultra DMA/66 implementation is possible only if your
IDE hard drive supports it and the operating environ-
ment includes a DMA drive and your system software
both support Ultra DMA/66, select Auto to enable
BIOS support.
The choice: Auto, Disabled.
The chipset contains a PCI IDE interface with sup-
port from two IDE channels. Select Enabled to acti-
vate the first and/or the second IDE interface. Select
Disabled to deactivate an interface if you install a pri-
mary and/or second add-on IDE interface.
The choice: Enabled, Disabled.
Select Enabled if your system contains a Universal
port Serial Bus (USB) controller and you have a USB
keyboard.
The choice: Enabled,Disabled
or AGP first.
The choice: PCI Slot, AGP.
commands, or multiple sector read/write. If your IDE
hard drive supports block mode (most new drives do),
select Enabled for automatic detection of the optimal
number of block read/write per sector the drive can
support.
The choice: Enabled, Disabled.
Mode 4.
65EB
47