Table of Contents
Advertisement
RMI-QE installation guide
Switches SW1 and SW2
2.10
CAUTION: When changing the RMI-QE's DIP switch settings use a suitable implement and take care
not to damage the switch.
NOTE: To gain access to the switches, remove the front cover, (see section 4, "Maintenance" for
further information).
Switch SW1 output configuration
CAUTION: When using error or probe SSR in NO mode, a wiring fault could cause loss of error
condition and therefore could result in a non-failsafe condition.
SW1
PROBE STATUS 1
Low
battery
Pulsed
NO
NO
ON
Level
NC
NC
SW2
Error
NO
Abbreviations are as follows:
•
NO = Normally Open
•
NC = Normally Closed
Factory settings are shown.
NC
Advertisement
Table of Contents
