Switches Sw1 And Sw2; Switch Sw1 Output Configuration - Renishaw RMI-Q Installation Manual

Switches SW1 and SW2

Switch SW1 output configuration

PROBE STATUS 1
Pulsed
ON
Level
CAUTION: Exercise caution when using error or probe SSR in N.O. mode; a wiring fault could cause loss of error
condition, and result in a non-failsafe condition.
SW1
Low
battery
Error
N.O.
N.O. N.O.
N.C. N.C. N.C.
SW2
NOTE: To gain access to the
switches, remove the front cover.
For more information, see section 4,
"Maintenance".
Abbreviations are as follows:
•
N.O. = Normally Open
•
N.C. = Normally Closed
Factory settings are shown.
2.7