RMI-Q installation guide
Switches SW1 and SW2
2.8
Switch SW1 output configuration
!
CAUTION: Exercise caution when using error or probe SSR in N/O mode as a wiring
fault could cause loss of error condition and therefore could result in a non-failsafe condition.
SW1
PROBE STATUS 1
battery
Pulsed
N/O
ON
N/C
Level
N/C
SW2
NOTE: To gain access to
the switches, remove the
front cover (see Section 4,
'Maintenance').
Low
Error
N/O
N/O
Abbreviations are as follows:
•
•
Factory settings are shown.
N/C
N/O = Normally Open
N/C = Normally Closed