Xilinx Alveo U200 Getting Started page 42

Upgrade
The following steps require XRT 2019.2 or later to be installed. For older installed versions of the
XRT, see v1.5 of Getting Started with Alveo Data Center Accelerator Cards (UG1301).
1. Restore the card to the original manufacturing state by following the instructions in
C: Reverting the Card to Factory
2. Remove the current XRT and installed platform(s).
$ sudo apt remove xrt
3. Follow the installation procedures outlined in
Downgrade
The following steps require XRT 2019.2 or later to be installed. For older installed versions of the
XRT, see v1.5 of Getting Started with Alveo Data Center Accelerator Cards (UG1301).
To downgrade perform the following steps.
1. Restore the card to the original manufacturing state by following the instructions in
C: Reverting the Card to Factory
2. Remove the current XRT and installed platform(s).
$ sudo apt remove xrt
3. Follow the installation procedures outlined in the chapter "Installing the Deployment
Software" in v1.5 of Getting Started with Alveo Data Center Accelerator Cards (UG1301).
Uninstalling Packages in Ubuntu
To completely uninstall the Alveo XRT and installed deployment platform packages, run the
following command in a Linux terminal. Uninstalling XRT also uninstalls the deployment platform.
$ sudo apt remove xrt
UG1301 (v1.8) February 5, 2021
Getting Started with Alveo Accelerator Cards
Appendix A: Changing XRT and Target Platform Versions
Image.
Chapter 4: Installing the Deployment
Image.
www.xilinx.com
Send Feedback
Appendix
Software.
Appendix
42