Xilinx Alveo U200 Getting Started page 48

An example output of this command is given below with available base partitions displayed
under the Flashable partitions installed in system. Only one base partition is
shown xilinx_u250_gen3x16_base_3.
Card [0000:65:00.0]
Card type:
Flash type:
Flashable partition running on FPGA:
xilinx_u250_gen3x16_base_3,[ID=0x48810c9d17860ef5],[SC=4.6.6]
Flashable partitions installed in system:
xilinx_u250_gen3x16_base_3,[ID=0x48810c9d17860ef5],[SC=4.6.6]
Use the following command to list the available shell partition.
$ sudo /opt/xilinx/xrt/bin/xbmgmt partition --scan
An example output of this command is as follows with available shell partition displayed under
the Partitions installed in system. Only one partition is shown
xilinx_u250_gen3x16_xdma_shell_3_1.
Card [0000:65:00.0]
Partitions running on FPGA:
xilinx_u250_gen3x16_base_3
logic-uuid:
48810c9d17860ef53e9e529e8b14ce39
interface-uuid:
695718ec21a232e45e1afcb4e558e11f
xilinx_u250_gen3x16_xdma_shell_3_1
logic-uuid:
bd5fb8abab266c3265918257b5048e88
interface-uuid:
f2f6c5e1273e78948f2c4806221462f2
Partitions installed in system:
xilinx_u250_gen3x16_xdma_shell_3_1
logic-uuid:
bd5fb8abab266c3265918257b5048e88
interface-uuid:
f2f6c5e1273e78948f2c4806221462f2
Note: A base and shell are compatible if the card plus customization and first version digit in the partition
names match.
The card_bdf is displayed on the first output line for either command in these examples is
0000:65:00.0.
Using the command options from the previous example, the command for flashing the base is as
follows,
$ sudo /opt/xilinx/xrt/bin/xbmgmt flash --update --shell
xilinx_u250_gen3x16_base_3 --card 0000:65:00.0
and the command for programming the shell is as follows.
$ sudo /opt/xilinx/xrt/bin/xbmgmt partition --program --name
xilinx_u250_gen3x16_xdma_shell_3_1 --card 0000:65:00.0
UG1301 (v1.8) February 5, 2021
Getting Started with Alveo Accelerator Cards
Appendix D: Obtaining xbmgmt Command Options
u250
SPI
www.xilinx.com
Send Feedback
48