Xilinx Alveo U200 Getting Started page 28

Use the following command, described in
for obtaining the card_bdf and shell_name options.
$ sudo /opt/xilinx/xrt/bin/xbmgmt partition --scan
After programming the shell, an output similar to the following example will be displayed.
Programming PLP on Card [0000:65:00.0]...
Partition file: /opt/xilinx/firmware/u250/gen3x16/xdma-shell/
partition.xsabin
Program successfully
After the shell partition is programmed, it is not necessary to reprogram it unless the system
is warm or cold rebooted.
IMPORTANT! Prior to running an application on DFX-2RP platform, it is necessary to first program
the shell partition on the card or the application will fail to detect the shell and will not run. See
Answer Record 71915
The installation for deployment is now complete.
Related Information
Card Bring-Up and Validation
UG1301 (v1.8) February 5, 2021
Getting Started with Alveo Accelerator Cards
Chapter 4: Installing the Deployment Software
Appendix D: Obtaining xbmgmt Command
for details.
www.xilinx.com
Send Feedback
Options,
Xilinx
28