Xilinx Alveo U200 Getting Started page 24

IMPORTANT! Assurez-vous d'éteindre complètement la machine, puis de la rallumer. L'image flash ne
démarrera pas si la machine n'est pas redémarrée.
WICHTIG! Schalten Sie das Gerät vollständig aus und wieder ein. Das Image startet nicht von Flash,
wenn der Computer nur neu gestartet wird.
10. Flash the Satellite Controller (SC) firmware to the Alveo card using the same command to
flash the base firmware. It has the following format:
$ sudo /opt/xilinx/xrt/bin/xbmgmt flash --update --shell <base_name>
See Appendix D: Obtaining xbmgmt Command Options
You will be asked to confirm the update, as follows. Type y and press the Enter key.
Status: SC needs updating
Current SC: <current_sc_version>
SC to be flashed: <sc_version_to_be_flashed>
Are you sure you wish to proceed? [y/n]: y
Flashing will take up to 5 minutes.
Successfully flashing the SC results in a message similar to the following. No reboot is
necessary.
Updating SC firmware on card[0000:65:00.0]
Stopping user function...
........................................
Successfully flashed Card[0000:65:00.0]
1 Card(s) flashed successfully.
If the card is up-to-date, you will see a message similar to the following.
Status: shell is up-to-date
Card(s) up-to-date and do not need to be flashed.
11. Program the shell partition using the following command.
$ sudo /opt/xilinx/xrt/bin/xbmgmt partition --program --name <shell_name> --card <card_bdf>
Use the following command, described in
for obtaining the card_bdf and shell_name options.
$ sudo /opt/xilinx/xrt/bin/xbmgmt partition --scan
After programming the shell, an output similar to the following example will be displayed.
Programming PLP on Card [0000:65:00.0]...
Partition file: /opt/xilinx/firmware/u250/gen3x16/xdma-shell/
partition.xsabin
Program successfully
After the shell partition is programmed, it is not necessary to reprogram it unless the system
is warm or cold rebooted.
UG1301 (v1.8) February 5, 2021
Getting Started with Alveo Accelerator Cards
Chapter 4: Installing the Deployment Software
for obtaining the command options.
Appendix D: Obtaining xbmgmt Command
Send Feedback
--card <card_bdf>
Options,
www.xilinx.com
24