Xilinx Alveo U200 Getting Started page 27

Bitstream guard removed from flash
Successfully flashed Card[0000:65:00.0]
1 Card(s) flashed successfully.
Cold reboot machine to load the new image on card(s).
If the card is up-to-date, you will see a message similar to the following.
Status: shell is up-to-date
Card(s) up-to-date and do not need to be flashed.
6. Cold boot your machine to load the new base firmware image on the FPGA.
IMPORTANT! Be sure to fully power OFF the machine and then power it ON again. The image will
not boot from flash if the machine is only rebooted.
IMPORTANT! Assurez-vous d'éteindre complètement la machine, puis de la rallumer. L'image flash ne
démarrera pas si la machine n'est pas redémarrée.
WICHTIG! Schalten Sie das Gerät vollständig aus und wieder ein. Das Image startet nicht von Flash,
wenn der Computer nur neu gestartet wird.
7. Flash the Satellite Controller (SC) firmware to the Alveo card using the same command to
flash the base firmware. It has the following format:
$ sudo /opt/xilinx/xrt/bin/xbmgmt flash --update --shell <base_name> --card <card_bdf>
See Appendix D: Obtaining xbmgmt Command Options
You will be asked to confirm the update, as follows Type y and press the Enter key.
Status: SC needs updating
Current SC: <current_sc_version>
SC to be flashed: <sc_version_to_be_flashed>
Are you sure you wish to proceed? [y/n]: y
Flashing will take up to 5 minutes.
Successfully flashing the SC results in a message similar to the one shown below. No reboot
is necessary.
Updating SC firmware on card[0000:65:00.0]
Stopping user function...
........................................
Successfully flashed Card[0000:65:00.0]
1 Card(s) flashed successfully.
If the card is up-to-date, you will see a message similar to the following.
Status: shell is up-to-date
Card(s) up-to-date and do not need to be flashed.
8. Program the shell partition using the following command.
$ sudo /opt/xilinx/xrt/bin/xbmgmt partition --program --name <shell_name> --card <card_bdf>
UG1301 (v1.8) February 5, 2021
Getting Started with Alveo Accelerator Cards
Chapter 4: Installing the Deployment Software
for obtaining the command options.
Send Feedback
www.xilinx.com
27