Wheel Diameter Setting; Speed-Limit Setting; Personalized Parameter Setting - King-Meter J-LCD User Manual

Press the [MODE] to shift, and add/subtract the input value by [UP] / [DOWN]. After the
4-digit password is inputed, press [MODE] to confirm.
If the password is correct, enter the power-on password enabled setting interface; otherwise,
stay in the password input state. Long press [MODE] to exit. The permission password is:
0512.

5.12.1 Wheel Diameter Setting

LD means Wheel Diameter. Press [UP] and [DOWN] to select the correct value to match the
wheel diameter. Selectable values include: 16, 18, 20, 22, 24, 26, 700C, 28, 29. Default
diameter is 26 inch.

5.12.2 Speed-limit Setting

When the running speed is faster than MAX SPEED, the controller will cut off the motor power.
MAX SPEED default setting is 25Km/h. LS means Limit Speed 12Km/h to 40Km/h is
selectable. Press UP/DOWN to select the favorite value, then hold MODE over 2 seconds to
confirm and quit the setting mode.

5.13 Personalized Parameter Setting

Personalized Parameter Setting can match variety requirements in use. Settings items are:
Battery Power Bar Setting, Pedal assistant level Setting, Over-current Cut , Pedal Assistant
No.15, Chenchang Road, Beichen Dist.Tianjin,300134,CN
Normal Parameter Setting Page
Wheel Diameter Setting Page
Limit Speed Setting Page
11
KING-METER TECHNOLOGY CO., LTD
Fax：+0086 022 8478 0358 Tel: +0086 022 8478 0378