Exit Setting - King-Meter J-LCD User Manual

The standard speed limit setting is based on this setting, not more than this
setting value. This setting is the priority version.
Button PAS Setting
PUS means pushing. Press UP/DOWN to choose Y/N. Short press MODE, Y means enable,
N means disable. Short press MODE to confirm and enter into PAS speed setting. The default
value is Y.
PAS Speed Setting
PU means pushing. Through setting PAS to adjust push speed to meet rider's requirements.
The scope is "20%-35%"by pressing UP/DOWN, short press MODE to enter into slowly start
up. Default value is 25%.
Slowly Start up Setting
SSP means slowly start up. The scope is 1-4, 4 means the slowest. Press [UP]/[DOWN ]to
choose. Long press [MODE] to confirm and exit setting. The default value is 1.

5.13.9 Exit setting

In the setting state, short press [MODE] is to confirm the input. Long press [MODE] is for
Interface of max speed limited setting
Interface of PAS pushing
Interface of PAS speed setting
Interface of slowly setting up
16
KING-METER TECHNOLOGY CO., LTD
No.15, Chenchang Road, Beichen Dist.Tianjin,300134,CN
Fax：+0086 022 8478 0358 Tel: +0086 022 8478 0378