Recover Default Setting; Preparation Before Starting - King-Meter J-LCD User Manual

saving the setting, then quit the setting state. Long press [DOWN], is to cancel the operating
but not saving setting data.
If there is not any operating in one minute, display will exit the setting state.

5.14 Recover default setting

DEF means recover default. Both press [UP] + [MODE] to enter recover default setting.
Pressing [UP], [DOWN] to convert Y or N. Y means do need to recover default setting; Y
means entering into password setting. Otherwise, display will exit. The default state is N.
Input password: 0368. Short press [MODE], [UP]/[DOWN] can increase or reduce the number.
After inputting 4 passwords, short press [MODE] to confirm. The interface is as below. When
display showed DEF: 00, it means recovering default state, then exiting.
In the recovery default, battery power, ODO and trip can not be recovered, but
starting up password can be recovered.

6. Preparation before Starting

Make sure all connectors tightened and the cables without damage.
Restore Default Setting Interface
Enter number interface page
Recover default interface
17
KING-METER TECHNOLOGY CO., LTD
No.15, Chenchang Road, Beichen Dist.Tianjin,300134,CN
Fax：+0086 022 8478 0358 Tel: +0086 022 8478 0378