How To Connect The Ethernet Cable - Moneris Go Plus Setting Up

How to connect the Ethernet cable

1. Uncoil your Ethernet cable; both ends of the cable will look the
same.
2. Turn the communication base upside down. Use one end of the
cable and insert it into the Ethernet port on the back of the base.
The Ethernet cable will clip in when it is inserted correctly.
3. Connect the other end of the Ethernet cable to your Ethernet
network infrastructure (modem, router, Ethernet wall ports, other
equipment). The Ethernet cable will clip in when it is inserted
correctly.
4. Turn the base right side up and dock the terminal on the
communication base. Ensure the terminal fits securely over the two
prongs on the base.
5. The terminal displays the charging screen.
a. Wait for the battery charging icon to display. This indicates that
the terminal is receiving power and the battery is charging.
b. Continue charging the terminal during the rest of the setup
procedures.
The Ethernet cable is now connected
6. Continue to How to pair the communication base with the terminal.
Moneris® Go Plus: Setting up Your Terminal 7