Table of Contents
Advertisement
Freescale Semiconductor, Inc.
APPENDIX A - ADI BOARD INSTALLATION
A.1
INTRODUCTION
This appendix describes the hardware installation of the ADI board into various host computers.
The installation instructions cover the following host computers:
1. IBM-PC/XT/AT
2. SUN - 4 (SBus interface)
A.2
IBM-PC/XT/AT to M68360QUADS-040 Interface
The ADI board should be installed in one of the IBM-PC/XT/AT motherboard system expansion slots. A
single ADI can control up to eight M68360QUADS-040 boards. The ADI address in the computer is
configured to be at I/O memory addresses 100-102 (hex), but it may be reconfigured for an alternate
address space.
BEFORE REMOVING OR INSTALLING ANY
EQUIPMENT
COMPUTER, TURN THE POWER OFF AND
REMOVE THE POWER CORD.
A.2.1
ADI Installation in IBM-PC/XT/AT
Refer to the appropriate Installation and Setup manual of the IBM-PC/XT/AT computer for instructions on
removing the computer cover.
The ADI board address block should be configured at a free I/O address space in the computer. The
address must be unique and it must not fall within the address range of another card installed in the
computer.
The ADI board address block can be configured to start at one of the three following addresses:
•
$100 - This address is unassigned in the IBM-PC
•
$200 - This address is usually used for the game port
•
$300 - This address is defined as a prototype port
The ADI board is factory configured for address decoding at 100-102 hex in the IBM-PC/XT/AT I/O address
map. These are undefined peripheral addresses.
M68360QUADS-040 Hardware User's Manual
CAUTION
IN
For More Information On This Product,
Go to: www.freescale.com
THE
IBM-PC/XT/AT
SUPPORT INFORMATION
51
Advertisement
Table of Contents
