Step 2: System Learning; A: Dual Gate; B: Single Gate - Richmond GTR500 User Manual

Step 2: System Learning

Step1:
Press and hold SET & DOWN buttons for 3 secs till the LED shows "LEA". Within 20 secs, press the "open-stop-
F1
close-stop" button on the remote or SET button on the control board. Then the motor runs the system learning
procedure automatically. Once the learning is completed, the LED will show "D-G" or "S-G". -
NC
Please check the parameter setting of "F1"(Dual/Single) before going into system learning.
Note:
Restore system default setting
P P ress ress and and
Hold the UP + DOWN
Note:
shows "D-G" tells the system learning has be completed for Dual Gate installation
1 1 . . . LE LED
2 2 . . . LED LE shows "S-G" tells the system learning has be completed for Single Gate installation
Press
3 Sec
1
Dual Gate
A.
(1) Slave Gate Close → (2) Master Gate Close → (3) Master Gate Open →
(4) Slave Gate Open → (5) Slave Gate Close → (6) Master Gate Close
1
4
B. Single Gate :
(1) Master Gate Close → (2) Master Gate Open → (3) Master Gate Close
1
14
Q17
+
NO
K5
button for 5 secs and panel restores back to default setting
LEA
2
2
5
2
D-G/S-G
3
3
6
3
PART B: Control System User Manual