Hmi Configuration Principles - Honeywell CIPer 50 User Manual

CIPer MODEL 50 CONTROLLER – USER GUIDE
TM

HMI configuration principles

To get the onboard HMI or detached HMI operational, the following configuration principles need to be done in
WEBs N4:
1. Add & enable the HMI Service.
2. Set a PIN for the HMI access.
3. Add HMI and LED Alarm recipients.
NOTE
As long as there are unacknowledged alarms in the station, the alarm symbol blink
regardless of the user is logged in to the HMI or not. See the picture below:
4. Configure the alarm for the HMI.
5. Fill the Fast Access Lists (FAL) with data points, schedules & parameters.
6. If desired, create a custom HMI sequence.
31-00198-03 6