CIPer
MODEL 50 CONTROLLER – USER GUIDE
TM
ATTENTION:
Due to the risk of short-circuiting (see below figure), it is strongly recommended that the CIPer Model 50
controller be supplied with power from a dedicated transformer.
However, if the CIPer Model 50 controller is to be supplied by the same transformer powering other controllers or
devices (e.g., the PW M-Bus Adapter), care must be taken to ensure that correct polarity is observed.
For more details on the Power supply connections and recommended VA ratings, refer to the Power Supply
section in the CIPer Model 50 Installation & Commissioning Instructions – 31-00233.
31-00198-03
20