Hmi Service - Honeywell CIPer 50 User Manual
Hide thumbs
Also See for CIPer 50:
- Installation & commissioning instructions (51 pages) ,
- User manual (44 pages) ,
- Installation & commissioning instructions (85 pages)
Table of Contents
Advertisement
HMI Service
The onboard and detached HMI will only work when the HMI Service, called "HonEagleHawkHmiService" has been
placed into the "Services" of your station.
IMPORTANT
Always place the "HonEagleHawkHmiService" into the "Services" folder.
Do NOT place it under any service within "Services"
Steps to configure HMI Service
1.
Select the "honEagleHawkHMI" palette and drag the "HonEagleHawkHmiService" into the "Services"
of your station.
2.
Enable the "HonEagleHawkHmiService".
3.
Changing, deleting, or translating the messages on the HMI.
4.
Changing or deleting can be done in the property sheet of the HMI Service – see below:
CIPer
TM
7
MODEL 50 CONTROLLER – USER GUIDE
31-00198-03
Advertisement
Table of Contents
