Restore The Ciper Model 50 Controller - Honeywell CIPer 50 User Manual

Restore the CIPer Model 50 controller

The CIPer Model 50 restore functionality has been enhanced to offer three levels of delete and restore, with three
different CleanDist files.
These CleanDist files allow each user to individually clean up the respective CIPer Model 50 controller according
to the requirements. To restore the CIPer Model 50 user needs to install the "Clean Dist" file.
NOTE
If there are any unsigned third-party modules with a release level of N4.10 or below connected to your
system, then any attempt to upgrade your controller may fail. For a successful controller upgrade, make
sure to sign all third-party modules using Niagara's Jar Signing Tool.
If the upgrade still not successful after signing the third-party modules, then you should perform the
factory reset using the clean-dist-honeywell-nxubc.dist file.
Choose one of the following "CleanDist" files to delete and restore settings on the CIPer Model 50 controller.
CleanDist Files Details
CleanDist Type CleanDist file
clean-dist-1-
CleanDist 1
honeywell-nxubc.dist
clean-dist-2-
CleanDist 2
honeywell-nxubc.dist
CleanDist 3 clean-dist-3-
(Restore CIPer honeywell-nxubc.dist
50 Controller to
factory out
settings.)
Which Elements are deleted?
Station
Module
System Passphrase
User & Password
Cleanup Service Folder
IPAddress
License and Certificates
Firmware
Version Description
1.2 Deletes all the station and modules.
Deletes all the station, modules, system passphrase,
1.4
username and password, and clean-up service folder
1.3 Deletes all the station, modules, system passphrase,
username and password, clean-up service folder, license,
and certificates. Also resets the IP address to its default i.e.
• Ethernet interface 1: 192.168.200.20, mask
255.255.255.0
•
Ethernet interface 2: 192.168.201.20, mask
255.255.255.0
Additionally, CleanDist 3 will reset the installed firmware to
the Factory Firmware Version 4.4.92.2.1.04.3.
CleanDist 1
X
X
--
--
--
--
--
--
35
CIPer MODEL 50 CONTROLLER – USER GUIDE
TM
CleanDist 2
X
X
X
X
X
--
--
--
CleanDist 3
X
X
X
X
X
X
X
X

Factory Default
31-00198-03