Enabling and Disabling Protocols Using the Control Panel
1.
Log in as the network administrator from the control panel.
2.
Press [System Settings].
3.
Press [Interface Settings].
4.
Press [Effective Protocol].
5.
Select the protocol you want to enable or disable.
6.
Press [OK].
7.
Log out.
Enabling and Disabling Protocols Using Web Image Monitor
1.
Log in as the network administrator from Web Image Monitor.
2.
Point to [Device Management], and then click [Configuration].
3.
Click [Network Security] under "Security".
4.
Select the protocol you want to enable or disable, or select the port you want to open or
close.
5.
Click [OK].
Enabling and Disabling Protocols
75