Separate Terminal Chamber (Stc) Connections; Replace Terminal Chamber Cover - Emerson Bettis SMART EHO G Series Service Instructions Manual

Section 3: Electrical Connections
September 2020
3.4

Separate Terminal Chamber (STC) Connections

3.4.1
3.4.2
3.4.3
NOTE:
The main power supply and ground wire connections are screw size M4.
The control connection screw size is M3.
3.5

Replace Terminal Chamber Cover

3.5.1
3.5.2
20 20
Connect the main power supply cables, including an Earth/Ground
(refer to the job specific Wiring Diagram).
Use the barrier strip clamp screws to connect the control wiring
(refer to the job specific Wiring Diagram).
Ensure all connections are hand tight, including any unused terminals.
Clean electrical enclosure threads thoroughly and lightly grease with dielectric
grease before closing.
Replace the cover by reversing the order of the steps to remove the cover.
Service Instructions
MAN-02-08-77-0714-EN Rev. 2
Electrical Connections