Table of Contents
Advertisement
Service Instructions
MAN-02-08-77-0714-EN Rev. 2
8.2.5
Figure 37
8.2.6
8.2.7
8.2.8
8.2.9
8.2.10 Toggle the NO/YES Selector Switch to NO to navigate through the Setting's values
NOTE:
Section 8.4 EHO Configuration Menu for an overview of the entire EHO Configuration Menu
and descriptive definitions and options of each setup selection displayed on the LCD Display.
8.2.11 If additional configurations must be made in the current Setting Category, repeat
8.2.12 If additional configurations must be made in another setting category, repeat
8.2.13 When all setting changes have been made, toggle the NO/YES Selector Switch
Customizing Smart EHO Settings
Please modify so that it shows the switch pointing to YES.
Change Settings (9)
Once in a Setting Category, the LCD Seven will show the Setting and its value by
flashing between the Menu Key and the Setting's value.
To navigate through the Settings, toggle the NO/YES Selector Switch to YES to
move to the next Setting.
To change a Setting's value, toggle the NO/YES Selector Switch to NO.
Once in a Setting, the LCD Display will show the Setting and its value by flashing
between the Menu Key and the Setting's value.
until the correct Setting's value is found. Toggle the NO/YES Selector Switch to YES
to confirm the Setting's value selected.
steps 8.2.5 and 8.2.8. To exit the current setting category, toggle the NO/YES
Selector Knob to YES until the Setting Category is displayed on the LED Display.
steps 8.2.3. to 8.2.9.
to NO until [E][E] is displayed on the LCD Display. [E][E] is Menu Key for the exit
option in the Setup Menu. Toggle the NO/YES Selector Switch to YES to exit Setup
Mode. Once Setup Mode has been exited, the SMART EHO display will return to the
normal display mode.
Section 8: Customizing Smart EHO Settings
September 2020
53
Advertisement
Table of Contents
