Table of Contents
Advertisement
Service Instructions
MAN-02-08-77-0714-EN Rev. 2
Figure 40
8.3.6
8.3.7
Figure 41
8.3.8
8.3.9
8.3.10 Once the Passcode has been accepted, the SMART EHO will navigate directly to the
NOTE:
When changing a factory setting(which cannot be changed), all the lights will flash for 2
seconds to signify this setting is a factory setting and cannot change.
Customizing Smart EHO Settings
Change Settings (12)
The underscore on the right of the LCD Display will now be flashing.
Toggle the NO/YES Selector Knob to NO until the right digit of the LCD Display
displays the number or letter corresponding to the Menu Key. Toggle the NO/YES
Selector Knob to YES once the number of letter for the Menu Key is found.
Change Settings (13)
Have switch pointing to YES.
After the setting has been entered, the Passcode must be entered. See instructions
in Section 8.2.3.1. to 8.2.3.6 for instructions on how to enter the Passcode.
entered Menu Key.
Section 8: Customizing Smart EHO Settings
September 2020
55
Advertisement
Table of Contents
