Main Menu - Drive Information - Group - Danfoss VLT CDS 803 Programming Manual

Parameters
14-63 Min Switch Frequency
Set the minimum switching frequency allowed by the output
filter.
Option: Function:
[2] 2.0 kHz
*
[3] 3.0 kHz
[4] 4.0 kHz
[5] 5.0 kHz
[6] 6.0 kHz
[7] 8.0 kHz
[8] 10.0 kHz
[9] 12.0 kHz
[10] 16.0 kHz
14-90 Fault Level
To customize fault levels, use this parameter.
Use [0] Off with caution as it ignores all warnings and alarms for
the selected source.
Option: Function:
[3] Trip lock
[4] Trip w.
*
delayed reset
[5] Flystart

3.11 Main Menu - Drive Information - Group

15
Parameter group containing frequency converter
information such as operating data, hardware configu-
ration, and software versions.
3.11.1 15-0* Operating Data
15-00 Operating hours
Range: Function:
0 h [0 - 0x7fffffff. View how many hours the
*
h] frequency converter has run. The
value is saved when the frequency
converter is turned off.
15-01 Running Hours
Range: Function:
0 h [0 - 0x7fffffff. View how many hours the
*
h] compressor has run. Reset the
counter in parameter 15-07 Reset
Running Hours Counter. The value is
saved when the frequency
converter is turned off.
15-03 Power Up's
Range: Function:
0 [0 - View the number of times the
*
2147483647 ] frequency converter has been
powered up.
MG18P202
Programming Guide
15-04 Over Temp's
Range:
0
*
15-05 Over Volt's
Range:
0
*
15-06 Reset kWh Counter
Option:
[0]
*
[1]
15-07 Reset Running Hours Counter
Option:
[0]
*
[1]
15-08 Number of Starts
Range:
0
15-09 Number of Auto Resets
Range:
0
3.11.2 15-3* Alarm Log
Parameters in this group are array parameters, where up to
10 fault logs can be viewed. [0] is the most recent logged
data, and [9] the oldest. Fault codes, values, and time
stamp can be viewed for all logged data.
15-30 Alarm Log: Error Code
Range:
0
*
Danfoss A/S © 06/2019 All rights reserved.
Function:
[0 - 65535 ] View the number of frequency
converter temperature faults that
have occurred.
Function:
[0 - 65535 ] View the number of frequency
converter overvoltages that have
occurred..
Function:
Do not reset
Reset counter To reset the kWh counter to 0,
select [1] Reset and press [OK].
Function:
Do not reset
Reset counter To reset the running hours counter,
select [1] Reset counter and press
[OK] (see also
parameter 15-01 Running Hours).
Function:
[0 - States the number of starts
2147483647 ] executed on the frequency
converter. The counter can be reset
in parameter 15-07 Reset Running
Hours Counter. The value is saved
when the frequency converter is
turned off.
Function:
[0 - States the number of auto resets
2147483647 ] executed by the frequency
converter.
Function:
[0 - 255 ] View the fault code and lookup its
meaning in chapter 4 Trouble-
shooting.
3 3
57