Nikon NPL-632 Instruction Manual page 77

8.
9.
10. To change the station name, move to the ST field
If you have set Split ST to Yes, the ST field defaults to the last recorded ST value + 1. For more information, see
Others settings, page 120.
11. To change the BS, press the
12. Select the BS point that you want to use and
13. To finish the resection setup, move the cursor to
The minimum data required for a resection is either three angle shots, or one angle shot and one distance shot.
If you use a distance shot, the distance between the target points must be greater than the measured distance.
Stn-Z is calculated from distance-measured data. If no distances are measured, then Stn-Z is calculated using
angle-only measurements to points with 3D coordinates.
If more than the minimum required data is
–
available, a standard deviation screen
appears.
To take measurements to strengthen
–
geometry of the resection, press the
softkey. For information about the
softkey, see Advanced feature: Viewing and
deleting a measurement in resection,
page 64.
When the results are satisfactory, record the
station. To do this, press
Enter the height of instrument, if required. Press
. The ST field defaults to the last recorded
[ENT]
PT + 1.
and edit or replace the text.
BS defaults to the first observed point.
press .
[ENT]
the BS field and press
Add
View
or the softkey.
REC
[ENT]
softkey.
Change
.
[ENT]
Field Station NPL-632 Instruction Manual
Applications 4
63