Table of Contents
Advertisement
3
Getting Started
Selecting the target set
A target set specifies settings for the target type, the
prism constant, and height of target. When you change
the selected target set, all three settings are changed.
You can use this function to quickly switch between
two types of target. You can prepare up to five target
sets.
Press
. A list of the five target sets appears. To select a target set, either press the
[ENT]
corresponding numeric key (
the list and press
To change the settings defined in a target set, highlight the target set in the list. Then
press the
Type
Const
HT
HT can be left blank in the target set. If you leave it blank, the current HT value is always applied to the
measurement.
When a target set is selected, the Type and Const values are copied to both [MSR1] and [MSR2] settings, and to
the measurements in Qcode. If you have specified a value for HT, this value is also copied to the current HT.
Entering a field note
To enter a field note, press
menu. Then either press
.
[ENT]
This function can be used at any time on any
observation screen.
Each note can be up to 50 characters.
The note is stored as a CO record in the raw data.
To display a list of previously used notes, press the
Stack
Use
[^]
to select the note.
[ENT]
40
Field Station NPL-632 Instruction Manual
to display the HOT menu. Then either press
[HOT]
.
[ENT]
softkey.
Edit
Prism / N-Prism
-999 to 999 mm
-9.9900 to 99.9900 m
[HOT]
, or select
[4]
softkey. The stack stores the last 20 notes.
or
to highlight a note in the list. Then press
[v]
through
), or use
[1]
[5]
[^]
to display the HOT
and press
Note
, or select
Target
[3]
or
to highlight the target set in
[v]
and press
Advertisement
Table of Contents
