Assembly - Fieldmann FDPP 200705-E User Manual

EN 12

Assembly

5. ASSEMBLY
Mounting/Replacing the Saw Blade
Removal of the Saw Blade
a. Press the Spindle Lock Button and keep pressing.
b. Loosen bolt clockwise with allen wrench, remove blade bolt and washer.
c. djust the base plate to the maximum cutting depth.
Note: When adjusting the base, press the Lock-off button fi rst and hold it.
d. Remove the saw blade from the machine.
Mounting the Saw Blade
a. Clean the saw blade and all clamping parts to be assembled.
b. Press the Lock-off button, then adjust the base plate to the maximum cutting depth and keep it.
c. Put the saw blade on the spindle.The cutting direction of the saw blade (or arrow) and the rotation direction
of the guard must correspond.
d. Restore the base plate to its original position.
e. Place blade bolt and washer on the saw blade successively and align the aperture.
f. Tighten the fastening bolts anticlockwise with a allen wrench.
Note:
Press the Spindle Lock Button and turn the allen wrench counterclockwise to check whether the bolts and saw
blades are tightened.
Install the Rip Guide
To install the rip guide on the machine, perform the following steps.
a. Unplug your plunge saw.
b. Insert the rip guide through all three slots on the base plate at the front of the saw, starting with slot in the left
side edge of the base.
c. Slide the left guide through the slots until it extends out the right side of the base plate.
d. Adjust the rip guide for the desired width of cut and then securely tighten the rip guide locking screw.
FDPP 200705-E