Ssd Installation - Supermicro SuperWorkstation 530A-IL User Manual

M.2 SSD Installation
Two M.2 SSD M key sockets and two form factors are
supported by this motherboard. M.2 sockets are used
for solid state storage and internal expansion. Follow
the steps below in order to install an M.2 SSD device.
1. Loosen the screw from M.2 standoff (pre-installed). Carefully plug the M.2 SSD device
into the M.2 socket and lower the semi-circle notched end onto the standoff.
2. Tighten the M.2 SSD with the screw removed in
Step 1.
•
To install the form factor of M.2 2280, relocate the
standoff where pre-installed on the 22110 mounting
hole, and then follow the steps above to install the
2280 device.
Chapter 3: Maintenance and Component Installation
AUDIO_FP
JPAC1
COM1
USB0/1
MH11
I-SGPIO2
MH14
JTPM1
SP1
JF1
JD1
JSTBY1
JPME2
JLED1
I-SGPIO1 PCI-E_M.2-M1
JSD1
JL1
JWD1
29
AUDIO
LAN2 LAN1
USB6/7 (3.2 (10Gb)) USB8 (3.2 (20Gb)) USB4/5 (3.2 (10Gb))
JPL2
BMC_HB_LED
PCI-E_M.2-M3
JPL1
MAC CODE
CATERR_LED
IPMI CODE
2280
MH10
BAR CODE
BIOS LICENSE
22110
2280
MH15
2280
X12SAE-5
PCI-E_M.2-M2
REV:1.00
DESIGNED IN USA
ALWAYS POPULATE GRAY SOCKET FIRST
UNBUFFERED ECC/NON-ECC DDR4 DIMM REQUIRED
PCH
JBT1
USB9 (3.2 (20Gb))
BT1
USB2/3 (3.2 (5Gb))
JPW1
SYS_FAN2
I-SATA4 I-SATA2 I-SATA0
I-SATA5 I-SATA3 I-SATA1
DP
DVI HDMI
CPU_FAN1
JPW2
CPU_FAN2
12V_PUMP_PWR1
JPI2C1
SYS_FAN1