Dimm Installation; Dimm Removal - Supermicro SuperWorkstation 530A-IL User Manual

DIMM Installation

1. Insert DIMM modules in the following
order: DIMMA2, DIMMB2, then DIMMA1,
DIMMB1. For the system to work properly,
use memory modules of the same type
and speed.
2. Align the DIMM module key with the
receptive point on the single-latch DIMM
slot.
3. Push the release tab outwards to unlock
the slot.
4. Press both ends of the module straight
down into the slot until the module snaps
into place.
5. Push the release tab to the lock position to
secure the module into the slot.

DIMM Removal

Reverse the steps above to remove the DIMM
modules from the motherboard.
Chapter 3: Maintenance and Component Installation
AUDIO_FP
BMC_HB_LED
JPAC1
MH10
COM1
BIOS LICENSE
USB0/1
MH11
I-SGPIO2
MH14
PCI-E_M.2-M2
JTPM1
JF1 SP1
JD1
JBT1
JSTBY1
JPME2
JLED1
BT1
I-SGPIO1
PCI-E_M.2-M1
JSD1
JL1
JWD1
I-SATA4 I-SATA2 I-SATA0
I-SATA5 I-SATA3 I-SATA1
Receptive Point
Release Tab
28
AUDIO
LAN2 LAN1
USB6/7 (3.2 (10Gb)) USB8 (3.2 (20Gb)) USB4/5 (3.2 (10Gb))
JPL2
PCI-E_M.2-M3
JPL1
MAC CODE
CATERR_LED
IPMI CODE
BAR CODE
MH15
X12SAE-5
REV:1.00
DESIGNED IN USA
ALWAYS POPULATE GRAY SOCKET FIRST
UNBUFFERED ECC/NON-ECC DDR4 DIMM REQUIRED
PCH
USB9 (3.2 (20Gb))
USB2/3 (3.2 (5Gb))
JPW1
SYS_FAN2
Notch
Push both ends straight
down into the memory slot.
DP
HDMI
DVI
CPU_FAN1
JPW2
CPU_FAN2
12V_PUMP_PWR1
JPI2C1
SYS_FAN1