Pci Expansion Card Installation - Supermicro SuperWorkstation 530A-IL User Manual

PCI Expansion Card Installation

After the motherboard has been installed, expansion cards may be installed.
Installing Expansion Cards
1. Begin by removing power
side cover as described in section 3.2.
2. Locate the release tab on the top of the PCI slot bracket.
3. Gently apply pressure in the middle of the release tab to unlock the PCI slot bracket.
4. Pull the release tab upward.
5. Remove the screw holding the bracket in place and pull the bracket from the chassis.
6. Install your PCI card or other add-on card into the PCI slot bracket and motherboard. To
do this, slide the PCI card (with "L" bracket) into the PCI slot and secure the card to the
motherboard.
7. Push the PCI bracket release tab down until it locks into place with an audible "click".
8. Secure the PCI card with the screw previously removed from the chassis.
9. Repeat this process with each PCI card you want to install into the chassis.
Chapter 3: Maintenance and Component Installation
from the system as described in Section 3.1 and
Figure 3-2. Installing Add-on Cards
30
remove the