Menu Structure - ProLights EclPanel TWCXL User Manual

9 - MENU STRUCTURE

The following chart describes the MENU tree of the product, the terms shown in BOLD indicate the
default settings. Functionalities with the "(WIP)" description are still under development.
MENU
1 CONNECT
Address
DMX Mode
Wireless
Ethernet
Settings
2 SETUP
Light
Control
DMX 1 - 512
WDMX
ArtNet
sACN
Refer to DMX Chart chapter
WDMX On-Off
ON/OFF
WDMX Transmitter
Receiver
mode
TX link On-Off
TX unlink On-Off
RX reset On-Off
On-Off
IN to WDMX
(TX)
On-Off
WDMX to
DMX (RX)
ArtNet IP Address
settings
Net
Subnet
Universe
sACN IP Address
settings
Universe
Merge
Mode
On-Off
Ethernet to
WDMX
On-Off
Ethernet to
DMX
Auto
Dimmer
Speed Fast
Medium
Slow
Off
Dimmer Linear
S-Curve
Curve
Square Law
Inverse Square Law
High Res@Low
Dimmer End Snap Off @ End
Fade Off @ End
PROLIGHTS - EclPanel TWCXL
Enable/Disable the wireless card.
Choose whether to set the wireless card as Transmitter
or Receiver.
WDMX mode is unlocked only if WDMX ON / OFF
is ON.
TX link unlock when the unit is set as a transmitter.
Disconnect the transmitter from all receivers.
TX unlink unlocks only if WDMX mode is on
transmitter.
Total reset of the receiver.
RX reset unlocks only if WDMX mode is receiver.
Enable/Disable the transmission of the dmx from the
transmitter to the receiver via wdmx.
Enable/Disable the retransmission of the DMX from
the receiver to the other units connected by cable to
the receiver itself.
Settings for ArtNet protocol use.
Settings for sACN protocol use.
Off
HTP
LTP
Enable / Disable DMX retrasmission from sACN/
ArtNet signal to WDMX (TX mode).
Enable / Disable DMX retrasmission from sACN/
ArtNet signal to DMX out port.
Set Dimmer Speed.
This parameter defines interpolation of DMX
Changes for main functions.
Off turns off interpolation
Choose dimmer curve.
Set Dimmer End behaviour.
Snap Off will make fixture snap when dimming out
to 0.
Fade Off will make fixture fade when dimming out to 0.
This selection affects only 004-000 DMX value
behaviour.
15