Analog Input; Table 2-27: Differential Analog Input 0 Specifications; Table 2-28: Analog Input Connector Pin Assignment (J106) - Aerotech Ensemble LAB Hardware Manual

Ensemble LAB Hardware Manual

2.5.7. Analog Input 0

To interface to a single-ended (non-differential) voltage source, connect the signal common of the source to
the negative input and the analog source signal to the positive input. A floating signal source should be
referenced to the analog common as shown in
Table 2-27: Differential Analog Input 0 Specifications
Specification
(AI+) - (AI-)
Resolution (bits)
Resolution (volts)
1. Signals outside of this range may damage the input
Table 2-28: Analog Input Connector Pin Assignment (J106)
Pin# Description
13 Analog Input 0 + (Differential)
14 Analog Input 0- (Differential)
24 Input Common
+
Signal Shielded
Source
Cable
-
www.aerotech.com
Figure 2-30.
ANALOGIN0+
J106-13
ANALOGIN0-
J106-14
ANALOG GND
J106-23
A
Figure 2-30: Analog Input 0 (J106)
Chapter 2
Installation and Configuration
Value
(1)
+10 V to -10 V
16 bits
305 µV
100
100
In/Out/Bi
Input
Input
-
+12V
AD622AR
+
-
A
-12V
55