Radio Frequency; Keep Away From Windows; Storage Temperature; Image Persistence - Advantech PAX-332 Series User Manual

Warning! High Voltage
The AC/DC inverter is equipped with the caution label shown below to
indicate the presence of high voltage current. Do not under any circum-
stances open the monitor to access the inverter. If servicing is required,
contact a qualified service technician.
4.6.1

Radio Frequency

This equipment generates, uses, and can radiate radio frequency energy and, if

not installed and used in accordance with the instructions, may cause harmful
interference to other devices in the vicinity. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to other devices, which can be determined by turn-
ing the equipment off and on again, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving device.
– Increase the separation between the equipment.
– Connect the equipment into an outlet on a circuit different from that to which
the other device(s) are connected.
– Consult the manufacturer or field service technician for assistance.
4.6.2

Keep Away From Windows

Exposure to rain, moisture, or sunlight can seriously damage the electrical com-

ponents. To protect the monitor from damage, do not place it near a window.
4.6.3

Storage Temperature

Do not place the monitor in an environment with a storage temperature of below

-20 °C (-4 °F) or above 60 °C (140 °F) as this can cause serious damage.
4.6.4

Image Persistence

Image persistence is when a residual or ghost image of a previous image

remains visible on the screen. Unlike CRT monitors, with LCD monitors image
persistence is not permanent, but constant images being displayed for a long
period of time should be avoided.
To alleviate image persistence, turn off the monitor for as long as the previous

image was displayed. For example, if an image was on the monitor for one hour
and a residual image remains, the monitor should be turned off for one hour to
erase the image.
Note! As with all personal display devices, Advantech recommends using a
moving screen saver whenever the screen is idle and turning off the
monitor when not in use.
31 PAX-332 User Manual