Table of Contents
Advertisement
Menu
Setting
Input Name
Set the name of the 12G-SDI 1, 12G-SDI
2, 3G-SDI, Display Port, HDMI, DVI-D
input connector.
Endoscope
Laparoscope
Ultrasound
Recorder
Printer
PACS
C-arm
Room Camera
Surgical Camera
Microscope
Vital Device
AUX IN Setting
Input Select
Select the connector to input the AUX IN
signal from "12G-SDI 1," "12G-SDI 2," "3G-
SDI," "Display Port," "HDMI," or "DVI-D."
Power Supply
DC Output Select
Select the connector for DC output
from "Off," "5V OUT," or "12V OUT."
Power Supply Port
When the 5 V output power of the DVI-
Select
D input connector is output, select
"DVI-D."
When the 3.3 V output power of the
Display Port input connector is output,
select "Display Port." When both of
them are not output, select "Off."
System Configuration menu
Menu
Setting
Control Lock
Control Lock
Set when you want to limit the
operation of the control panel. Set to
"Off" for no limit, "On" to limit.
Lock Mode
Sets the range to limit the operation of
the control panel. This setting is
available when "Control Lock" is set to
"On."
Menu:
Limits the menu operations other
than the control lock setting.
Menu&Button:
Limits all operations other than the
control lock setting.
OSD Setting
Menu Position
Sets the screen position for the OSD
menu.
Status Display
Select Port, Input Connector Name,
Control Lock, Signal Format, Scan Size,
4K Zoom, Flip Pattern, PIP/POP Mode,
A.I.M.E., Energy Saving Mode, and 2D/
3D Display are displayed.
Menu
Input Connector Name
Select Port
Flip Pattern
A.I.M.E.
PIP/POP Mode
Energy Saving Mode
2D/3D Display
32
Setting
Control Lock
Signal Format
Scan Size/
4K Zoom
2D/3D Display
Auto:
The format and scan mode are
displayed temporarily when the
content of Status Display is
changed.
On:
The format and scan mode are
always displayed.
Off:
The format and scan mode are not
displayed.
Notes
Even if "Status Display" is set to
"Auto" or "Off," the flip pattern is
always displayed.
For details about the signal format,
refer to no signal and non
compatible signal displays.
Input
Signal format
display
No signal
No Sync
Non compatible
Unknown
signal (except for
DVI-D)
Non compatible
Out Of Range
signal (DVI-D)
Select the display method of OSD to
show the currently set display method
from among 2D, 3D, or 3D to 2D
Convert.
Auto:
The method is displayed for about 3
seconds after the status of 2D, 3D,
or 3D to 2D Convert is changed, or
when Status Display is displayed.
On:
The method is always displayed.
Off:
The method is not displayed.
Advertisement
Table of Contents
