Vega POINTRAC 31 Operating Instructions Manual page 18

5 Connecting to power supply
18
4
Insert the cable into the sensor through the cable entry
Fig. 7: Connection steps 4 and 5
1 Locking of the terminal blocks
5
Insert a small slotted screwdriver firmly into the rectangular locking
openings of the respective connection terminal
6
Insert the wire ends into the round openings of the terminals
according to the wiring plan
Information:
Solid cores as well as flexible cores with cable end sleeves are
inserted directly into the terminal openings. In case of flexible cores
without end sleeves, press the rectangular locking opening with a
small screwdriver; the terminal opening is freed. When the screwdriver
is released, the terminal opening closes again.
7
Check the hold of the wires in the terminals by lightly pulling on
them
To loosen a line, insert a small slotted screwdriver firmly into the
rectangular locking opening according to the illustration
8
Connect the screen to the internal ground terminal, connect the
outer ground terminal to potential equalisation
9
Tighten the compression nut of the cable entry. The seal ring must
completely encircle the cable
10 Screw the housing cover on
POINTRAC 31 • 8/16 mA/HART - four-wire
1