Vega POINTRAC 31 Operating Instructions Manual page 31

Further settings/Date
time
Additional settings/Re-
set
POINTRAC 31 • 8/16 mA/HART - four-wire
6 Set up with the indicating and adjustment module
This parameter is described in the operating instructions manual
"Indicating and adjustment module".
In this menu item you can set the actual date and time.
This parameter is described in the operating instructions manual
"Indicating and adjustment module".
When a reset is carried out, all settings (with only a few exceptions) are
reset. The exceptions are: PIN, language, SIL and HART mode.
The following reset functions are available:
Basic settings: Restoring the parameter adjustments at the time of
shipment Ex factory including the order-specific settings. The
measured value memory is deleted.
Factory settings: Resetting the parameter adjustment including
special and laboratory parameters to the default values of the
respective instrument. The measured value memory and the order-
specific settings will be deleted.
Peak values measured value: Resetting of the parameter adjust-
ments in the menu item "Setup" to the default values of the respective
instrument. Order-specific settings remain, however are not taken over
into the actual parameters. The measured value memory as well as the
event memory remain.
Peak values temperature: Resetting of the measured min. and max.
temperatures to the actual measured value.
The following table shows the default values of the instrument.
Depending on the instrument version, not all menu items are available
or differently assigned:
31