Fig. 4
Fig. 5
Fig. 6
Assemble the thruster to support, now integral with the hull, using the provided bolts. In this phase, seal the contact area
between support and thruster using a specific sealer for marine use (not provided).
WARNING: scrupulously comply with the specific indications of the used sealer.
RETRACTABLE THRUSTER BTQR18 DP - IT GB - REV001A
Realise the opening in the hull for tunnel passage, by cutting the hull along the
outlined perimeter.
Align the support to the pre-established position and resin it, weld it in case of
aluminium or steel, according to the techniques identified as most suitable for
the type of hull construction.
INSTALLATION
GB
17